To Next PageTo Next PageWhat to do if Selve SP motor does not work?
If the Selve Engine motor isn't working, first, check the electrical connection to ensure it's properly connected. Also, the thermal protection switch might have triggered. In that case, wait for 5 to 20 minutes to see if it resets.
Why are the UP and DOWN directions switched on my Selve SP Engine?
If the UP and DOWN directions are switched on your Selve Engine, it's likely due to the black and brown wires being connected incorrectly to the switch. To fix this, switch the wires, ensuring the black wire is connected to DOWN and the brown wire is connected to UP.
Important safety notes for installation and operation.
Specifies the intended use of SELVE motors.
Detailed steps for installing the motor into the shaft.
Methods for mounting and supporting the SELVE motors.
Instructions for connecting and disconnecting the pluggable cable.
Wiring diagram and connection instructions for the motor.
Procedure for setting the upper and lower limit positions.
Detailed technical specifications for SELVE motors.
Declaration of compliance with EU directives.
Common problems and their solutions.
Contact information for technical support.
General
