Why Selve SE Plus 2/7 Engine motor does not work?
If your Selve Engine motor isn't working, there could be a couple of reasons. First, check the electrical connection to ensure it's properly connected. Second, the thermal protection switch might have been activated. If this is the case, wait for 5 to 20 minutes to allow the switch to reset.
What to do if Selve SE Plus 2/7 motor has stopped automatically when moving UP?
If your Selve Engine motor stops automatically while moving up, it's likely that the overload recognition has been triggered. You should remove any obstacles, check the curtain path for obstructions, and consider whether a stronger motor is needed.
What to do if Selve SE Plus 2/7 motor has stopped automatically when moving DOWN?
If the Selve Engine motor stops automatically when moving down, it indicates that blockage recognition has been triggered. Remove any obstacles and check the curtain path to ensure it is free from obstructions.
How to fix switched UP and DOWN directions on Selve Engine?
If the UP and DOWN directions are switched on your Selve Engine, there are two possible causes: 1. The end positions were set incorrectly; you should reset them. 2. The black and brown wires are connected to the switch incorrectly; switch the wires (black = DOWN, brown = UP).
Provides crucial safety information for both installation and operational phases of SELVE motors.
Specifies that the SE Plus motor is intended for operating awnings or roller shutters.
Details features like self-programming overload detection in the upwards direction.
Step-by-step guide on fitting the motor into the drive shaft, including adapter selection.
Explains methods for supporting SELVE motors using squares, flanges, or mounting plates.
Instructions for connecting and disconnecting the pluggable motor cable safely.
Details the wiring diagram and color coding for electrical hookup.
Outlines methods for setting end positions using switches and discusses mechanical requirements.
Details the process for semi-automatic end position setting and deletion.
Explains manual end position setting where the top limit acts as a stop/release.
Details manual end position setting for two distinct fixed points.
Procedure to reset the motor to factory default, deleting all set end positions.
Presents a table of torque, speed, power input, and output for different motor series.
Provides nominal voltage and safety class applicable to all motor types.
Declaration of conformity with EU directives for the SE Plus motor.
Lists common problems, their causes, and solutions for the SE Plus motor.
Contact information and resources for customer support and manual downloads.
To Next Page
General
