GB
GB
31
Reset
5. Reset
Precondition: Both end positions must be set, this means, the drive does no longer
make any moving interruptions during operation.
Reset with
switch
Reset with
setting switch
Drive
E
1 s Connect the setting switch cable to the motor
wiring cable.
Press the E button of the setting switch for
1 second. Both limit positions already set will be
deleted.
Alternatively: Move the drive upwards until it stops
automatically at the upper limit stop and performs
a short release.
5x 3 s with
1 s pause
Then press the switch 5 times for 3 seconds with
1 second pause in upwards direction.
Then turn on the upward direction again. The drive
moves down and switches off automatically. Now
turn off the switch.
Both limit positions already set will be deleted. Start the setting of the end limit
positions once again (4.5.1.).
To Next Page
Loading...
