Model 0200 – POP-0120 Rev 0
508.366.1488 | www.semshred.com
With Cabinet
1. Carefully remove unit from pallet and remove from packaging. Retain packaging for 90 days.
a. Open top of box.
b. Remove the hard top and foam corner pieces.
c. With another person, tilt the box toward you and pull the unit towards you out of the box while
the other pulls the box away.
2. Check that the power switches are in the off position before plugging the unit and the vacuum into a
wall plug capable of delivering 10 amps to each cord. Do not use a power strip. Ensure both plugs are
grounded.
3. Unit is ready for use.
Figure 3 – Cabinet Unit
Figure 4 – Inside Cabinet
To Next Page
Loading...
