Semacon S-1625 - Control Panel Functions; UV Counterfeit Detection; MG Counterfeit Detection

5
CONTROL PANEL FUNCTIONS
The START/STOP button is used to restart the counting process after the
machine stops during batch counting or after an error occurs.
THRU
The number buttons are used for selecting the batch stop setting. In this mode,
the counter will stop each time the batch stop setting is reached and the operator
then removes the batch from the stacker. Batch stop settings between 1 and 999
bills can be entered. The batch stop setting will appear on the display above
BATCH (see Figure 1). The selected batch number can be cleared by pressing the
0/C button. This deactivates the batch stop mode.
The CLR button clears the quantity of banknotes counted, which appears on the
screen of the display panel above COUNT (see Figure 1). The counting process is
then reset to begin again at “0”.
The ADD button switches between ADD mode and NORM (or NOM) mode.
When the machine is in ADD mode, the machine will add the count for each stack
of bills to the previous total. In NORM mode, the total is cleared each time a
stack of bills is removed from the stacker.
The UV button turns on/off the Ultraviolet Counterfeit Detection feature. When
Ultraviolet Counterfeit Detection is activated, UV (or U)
will appear above
MODE on the display and the counter will scrutinize the paper of each banknote
during the counting process to determine if there are any suspect counterfeit
notes. If a suspect counterfeit banknote is detected, the counter will stop and
alert the operator. If you are experiencing too many false UV suspects, the UV
detection feature should be adjusted or deactivated.
(This feature applies to models S-1615 and S-1625 only)
The MG button turns on/off the Magnetic Counterfeit Detection feature. When
Magnetic Counterfeit Detection is activated, MG (or M)
will appear above
MODE on the display and the counter will scrutinize the ink of each banknote
during the counting process to determine if there are any suspect counterfeit
notes. If a suspect counterfeit banknote is detected, the counter will stop and
alert the operator. If you are experiencing too many false MG suspects, the MG
detection feature should be adjusted or deactivated.
(This feature applies to model S-1625 only)
The SPD button adjusts the counting speed of the machine. When this button is
pressed, the number below SPEED on the display will switch between 1000,
1200, 1500, and 1800, with 1000 being the slowest counting speed and 1800
being the fastest. The recommended setting is 1500.