7
MODES AND FUNCTIONS
Add Mode
Adding during count mode is performed by pressing the ADD button (NORM will switch to ADD
beneath AD D on the display). With this mode turned on, the machine will add the count for each
stack of bills to the previous total.
Auto and Manual Start Mode
Normally, the counter starts counting automatically when bills are placed in the hopper. This
Auto Start Mode is indicated with an A on the display below AUTO. If you do not want the
machine to start counting automatically, press and hold the number 1 key until M appears below
on the display below AUTO. This will activate Manual Start Mode. In this mode, the machine
won’t start counting until the START/STOP button is pressed.
Batching
1) Select any number from 1-999 above BATCH on the display by pressing the numeric keys on
the control panel. For example, to preset the batch number “50”, press the 5 key and then press
the 0/C key.
2) Place banknotes in the hopper. The machine will start counting and will stop once the
counted number reaches the preset batch stop setting.
3) To repeat batch counting, simply remove the banknotes from the stacker and the machine will
count the next batch.
4) To clear the batch stop setting, press the 0/C button until nothing appears above BATCH on
the display.
NOTE: Add mode can also be used when batching if the operator selects a batch stop setting
while the ADD mode is activated.
To Next Page
Loading...
