nd average speed will be calculated for a given trip and
will reset when the bike is powered off. When the bike
has not been used for 10 consecutive minutes, the
display will automatically shut down. The pedal assist and
throttle features will no longer work when the display is
turned off.
Walk Mode
In general, electric bikes are heavier than regular bikes.
This makes walking the e-bike a more strenuous activity.
To make walking the e-bike easier, Senada bikes are
equipped with walk mode.
If you hold down the down button on the display control
pad, the motor will engage at a speed similar to a slow
walk. Once you release the down button, the motor will
stop running.
To deactivate walk mode, simply pull the brake levers to
engage the motor inhibitors or press and hold the down
button again.
Cruise Control
Cruise control on Senada bikes works similarly to cruise
control in a car. To activate: hold the down button while
twisting and holding the throttle. The bike will try to
maintain a speed based on the position of the throttle
when cruise control was activated.
For example, if the throttle is held all the way from its
resting position (to a position that would normally
maintain 20 km/h) and the down button is held, cruise
control will be activated and set at 20 km/h. Even if the
bike is currently going slower than 20 km/h, the bike will
try to accelerate and maintain that speed because it was
set based on that throttle position.
To cruise at low speeds, only slightly twist the throttle and
hold the down button. Cruise control can be deactivated at
any time by pulling the brakes, twisting the throttle again,
or holding the down button. This will also cut power to the
motor as it would during normal operation.
Display Settings
To Next Page