the bike’s top speed. Laws vary by trail, path, and road, so be
sure to check in each new location where you will be riding.
To change the top speed of the e-bike:
1. Access the settings menu by pressing and holding the up
and down buttons on the display simultaneously until the
screen shows “P01”.
2. From here, you can cycle through settings by clicking the up
and down buttons on the display to adjust the settings to
“P08”.
3. Please go to setting “P08” and click the button to flash
the value number of
“P08”. Change the value from 100 to 25
(Suppose you want to adjust the maximum speed to no more
than 25 km/h).
4. Hold the button on the control pad until the main screen
is shown once again.
5. Turn the bike off by holding the power button to save the
settings you have just changed.
Battery Capacity Display
On the top of the LCD display, a battery indicator bar can be
found which is labeled “energy bar”. This battery indicator
shows the estimated charge left in the bike’s battery. As the
battery depletes, tick marks will begin to disappear according
to approximately how much charge has been used. The
various charge level indicator states are shown below. The
battery display will flash when there is no charge remaining.
Note: The energy bar will not always be accurate. The energy
bar updates every few minutes based on the voltage of the
battery. The voltage of the battery will change constantly
while it is in use. When the current draw from the battery
increases, such as on an uphill slope, the voltage will
decrease. So it is normal for the battery bar to suddenly
decrease when going uphill.
To Next Page