6
SYMPTÔME
Fuite d’air près du sommet
de l’outil / fonctionnement lent.
SOLUTION
Serrezlesvisàfond/vérifiez
l’alimentation en air ou remplacez
les pièces portant la lettre “A”.
SYMPTÔME
Fuite d’air près de la base
de l’outil / retour inadéquat.
SOLUTION
Serrez les vis à fond / nettoyez
l’outil ou remplacez les pièces
portant la lettre “A”.
SYMPTÔME
Autres problèmes.
SOLUTION
Prenez contact avec SENCO.
SYMPTOM
Air leak near top of tool /
Sluggish operation.
SOLUTION
Verify air supply / tighten screws or
installPartsKitYK0373.
SYMPTOM
Air leak near bottom of tool /
Poor return.
SOLUTION
Clean tool / tighten screws or
installPartsKitYK0373.
SYMPTOM
SOLUTION
Contact SENCO.
Other problems.
SÍNTOMA
El aire se escapa cerca de la parte su-
periordelaherramienta/Operación
lenta.
SOLUCIÓN
Aprietelostornillos/Verifiqueel
suministro de aire o instale el
JuegodePartesA(PartsKit
YK0373).
SÍNTOMA
SOLUCIÓN
El aire se fuga cerca de la parte
inferior de la herramienta / Mal
retorno.
Apriete los tornillos / Limpié la
herramientaoinstaleelJuegode
PartesA(PartsKitYK0373).
SÍNTOMA
SOLUCIÓN
Otros problemas.
Póngaseencontactocon
SENCO.
English
Español
Français
Troubleshooting
IdentificacióndeFallas
Dépannage
WARNING
Repairs other than those described
here should be performed only by
trained,qualifiedpersonnel.Contact
SENCO for information at
1-800-543-4596.
ALERTA
Las reparaciones, fuera de aquellas
descritas aquí, deben de ser lleva-
das a cabo solamente por personal
entrenadoycalificado.Póngase
en contacto con SENCO para
información
1-800-543-4596.
AVERTISSEMENT
Les réparations autres que celles
décrites ici doivent être réalisées
uniquement par du personnel
qualifiéayantreçulaformation
appropriée. Pour toute information,
prenez contact avec SENCO par
téléphone en appelant Le Distribu-
teur agréé.
ä=Read and understand “SAFETY
INSTRUCTIONS” manual
shipped with this tool before
using tool.
ä=Antes de usar la herramienta lea
y comprenda el manual “INS-
TRUCCIONES DE SEGURI-
DAD” despachado con ella.
ä=Lisez et assimilez le manuel
“INSTRUCTIONS DE SÉCU-
RITÉ” livré avec cet outil avant
de l’utiliser.
A=YK0373