EN-9
BASIC OPERATIONS
Power / MUTE button
Press the power button to switch the unit ON. Long press again to switch it OFF. Press the button briefl y to Mute. Please note
that the volume will be muted on all audio output connectors. The MUTE icon will be seen on the information display. To resume
playing, press the button briefl y again.
Volume knob
Increase or decrease the volume by turning the Volume knob clockwise or counterclockwise. When the unit is switched off, it
will start on the INVOL volume level next time it is switched on.
System Settings
Increase or decrease the volume by turning the Volume knob clockwise or counterclockwise. When the volume level is below
20 and the unit is switched off, the unit will default set the volume at 20 the next time it is switched on. When the volume level
is higher than 20, the unit will default set the volume at 20 the next time it is switched on.
Short press SEL button to select the Audio functions in the following sequence:
VOLUME → BASS → TREBLE → BALANCE → FADER → CURRENT MODE
When BASS or TREBLE is selected, rotate the volume knob clockwise to boost Bass or Treble, rotate the volume knob
counterclockwise to decrease Bass or Treble.
When BALANCE is selected, rotate the volume knob clockwise to boost the volume to the right (R), rotate the volume knob
counterclockwise to boost the volume to the left (L).
When FADER is selected, rotate the volume knob clockwise to boost the volume to the rear (R), rotate the volume knob
counterclockwise to boost the volume to the front (F).
In Radio mode Press the SEL button for over 2 seconds to enter the setup menu. Press each time for a following selection:
(AF → INVOL → ADJ → 12/24HOUR → TAVOL → EON → PTY →REG → LOC → MONO → LOUD → SUB →
BEEP → DSP→ EXIT).
When AF is selected, rotate the volume knob to select AF OFF or ON.
Rotate the volume knob counterclockwise to decrease the default startup volume.
When ADJ is selected, rotate the volume knob clockwise to set the time.
When 12/24HOUR is selected, rotate the volume knob to change to 12 or 24 Hour format.
When TAVOL is selected, rotate the volume knob clockwise to boost the TA volume, rotate the volume knob counterclockwise
to decrease the TA volume.
When EON is selected (ON is default), rotate the volume knob to select ON or OFF.
When PTY is selected, rotate the volume knob to select PTY ON or OFF.
When REG is selected , rotate the volume knob to select REG ON or OFF.
When LOC is selected, rotate the volume knob to select ON or OFF. ON to select the short distance or local radio station mode
(LOC) or select OFF for long distance radio stations.
When MONO is selected, rotate the volume knob to select OFF (Stereo) or ON (Mono).
When LOUD (Loudness) is selected, rotate the volume knob to select ON, or OFF (default).
When SUB is selected , rotate the volume knob to select ON or OFF
When BEEP is selected, rotate the volume knob to select ON or OFF.
When DIGITAL SOUND PROCESSOR (DSP) is selected, rotate the volume knob to select a predefi ned equalizer sound effect
according your liking in the following sequence:
NONE → POP → ROCK → CLASSIC → FLAT → NONE
Note: After 5 seconds of non operation the display will return to the default of the selected mode. If the clock display is
enabled the unit will show the clock in standby mode.
To Next Page
Loading...