Sencor SCE 7000BK - Page 3

- 3 - Copyright © 2019, Fast ČR, a.s. 09/2019
ATTENTION:
Never fill the coffeemaker above the maximum level because hot
frothy coffee may overflow while being heated.
■ Before connecting the appliance to apower socket, check that the rated
voltage on its rating label matches the electrical voltage in the power socket.
■ Connect the appliance only to aproperly grounded socket. For safety
reasons, we do not recommend using multi-socket adapters or extension
cords.
■ Do not place the appliance on window sills, kitchen sink drainboards or
unstable surfaces. Always place it on astable, even and dry surface.
■ Do not place the appliance on or near an electrical or gas stove, or in the
vicinity of an open flame.
■ Never use the appliance in the near vicinity of abath, shower or swimming
pool.
■ Do not use the lid of the coffee bean hopper as asurface for placing objects on.
■ Only use the appliance with the original accessories that came with it.
■ Use the appliance with the glass kettle that came with it. Do not overfill the
glass kettle or place it on other sources of heat or use it for heating liquids
or food in amicrowave oven.
■ Do not use the appliance with akettle that is cracked or that has aloosened
or damaged handle, etc. If the kettle exhibits any signs of damage, it must
be replaced with anew one.
■ The appliance must not be used without the filter holder and the coffee
filter. Never pour coffee or coffee beans directly into the filter holder.
■ Hot steam is released from the vents during operation. For this reason,
provide the appliance with at least 20cm of clearance space.
■ Pour only roasted coffee beans into the coffee bean hopper. Before using
the appliance, always check that the lid has been correctly set.
■ The coffee bean hopper is not intended for storing coffee beans.
■ Fill the water tank with clean cold water. Do not pour hot water or other
liquids into it or place any items inside it. The maximum capacity of the
water tank is 1.6l. Do not overfill the water tank.
■ Before turning on the appliance, make sure that the water tank is filled with
asufficient amount of water, that the lid of the appliance is properly closed
and that the kettle is placed on the hotplate. The water level in the water
tank must not exceed the maximum mark.