Sencor SMW 6002DS - Installation

Microwave oven
SMW 6002DS
INSTALLATION
1) Make sure that you have taken all packaging materials, such as plastic bags, polystyrene, etc. out
from inside the oven.
2) WARNING: Check the oven for any damage, e.g. whether the oven doors are correctly seated or
dented, whether the seal on the door or other parts is damaged, or the door hinges and locks are
destroyed or loosened or whether the inside of the oven or door is dented. If you discover any
damage, do not use the oven and contact a qualified repair person.
3) The microwave oven must be placed on an even, stable surface, that can bear its weight
even with the food inserted.
4) Do not located the oven near sources of heat, in locations with increased humidity or near
flammable materials.
5) For proper operation the oven must have sufficient ventilation. Allow free space of 20 cm above
the top surface of the oven, 10 cm from behind and 5 cm on the sides. Do not block any opening of
the oven. Do not remove the legs of the oven.
6) The appliance is designed to be used in free space, it is not designed to be built-in.
7) Do not use the oven without the rotating glass plate, rotating ring and drive mechanism installed.
8) Never place the rotating plate upside down. Te glass plate must never be blocked or otherwise
restricted in its movement. If the rotating ring or the glass plate are damaged or destroyed contact
you nearest retailer or authorised service centre. Always place all food and containers on the glass
plate.
9) Make sure that the power cord is not damaged, or under the under side of the oven or in contact
with hot or sharp surfaces.
10) The electrical power socket must be easily accessible for the situation, where it may be necessary to
quickly pull out the power cord.
11) Do not use the oven outdoors.
EN-5
Copyright © 2013, Fast CR, a. s. Revision 04/2013