Sencor SVC 510GR - Assembly and Initial Setup; Connecting the Vacuum Cleaner Hose; Using Your Vacuum Cleaner; Connecting to Power

Bagless Vacuum Cleaner
SVC 510GR / SVC 511TQ / SVC 512VT (Allegro)
EN
EN-7
2019 05/2019
C
1 Handle
2 Front wheel mechanism
3 Vertical parking position
4 Motor air inlet
1
2
3
4
ASSEMBLY
Inserting the hose into the air suction hole on the vacuum cleaner:
Insert the hose end into the hole in the vacuum cleaner and turn it so that both lugs on the hose end lock in.
Thehose is now secured in correct position.
Attach the holder to the tube:
Make sure to place the holder with the hose on the wider part of the tube.
Attach the floor inlet nozzle to the tube:
Place the oor nozzle on to the narrower part of the tube and place the second part of the tube on to it.
USING YOUR VACUUM CLEANER
Connecting your vacuum cleaner to the electrical power grid
Pull the plug attached to the power cord out from the vacuum cleaner until the desired length of the cord is out
of the product. Insert the plug into the power socket.
Caution:
Yellow marking on the power cord warns that the power cord is close to its end. Do not pull
the cord further than the red marking.
Adjusting the floor inlet nozzle according to the floor surface.
You may set the inlet nozzle according to the oor surface by adjusting the inlet ap:
• If you want to vacuum carpets, close the bristles of the inlet inside the inlet nozzle, by turning the ap
accordingly.
• If you want to vacuum hard and smooth surfaces, move the bristles out of the nozzle, by turning the ap
accordingly.