Sencor SWS 290 - Main Unit Operating Instructions; Default Mode Operation; Time and Date Setting; Alarm and Snooze Configuration

EN - 4
MAIN UNIT OPERATING INSTRUCTIONS
Connect the product to power via 5V Mini USB cable, ON/OFF switch to “ON”, backlight will
be on, the product will self-check and full-screen display automatically and then display initial
time 0:00. generate “Bi Bi Bi” sound at the same time, LCD full-screen display 3 seconds.
then enter into standard mode. Please unplug insulating strip at the bottom of the product.
● Alarm default: 7:00
● Temperature default: °C
● Time format: 24HR
● Weather graphics: Sun with Cloudy.
● Calendar default: 2008 Jan, 1 st
DEFAULT MODE
● In default mode, short pressing “M/S” will display
● When turn to date mode or alarm without operating, it will return to clock display after 8
seconds.
● When turn to alarm display, press “+/CH”, control alarm on/ off.
● Long pressing “M/S”, can set data that displaying.
● Short pressing “MEM”, can check maximum, minimum data about temperature and
humidity
● Long pressing “MEM”, can clean data about humidity and temperature.
● Short pressing “–/CF” can select “°C/°F” format.
● Long pressing > 2 seconds
● Short pressing is 1 second
● When seting data: “+/CH” means adding, “–/CF” means reducing.
● After 30 seconds without operating, current setting datas will be kept by itself.
TIME SETTING
In normal time mode, long pressing M/S and enter into time setting mode. 24HR will fl ash,
short press “+/CH” to select 12HR/24HR format. Press “M/S”, Time display will blink, press
“+/CH”, “–/CF” to set hour. Press M/S, turn to set minutes. Minutes digital blink, press “+/CH”,
“–/CF” to set minutes.
And press M/S to fi nish time setting.
DATE SETTING
In normal time mode, short pressing “M/S”, will display date. Long pressing “M/S”, year will
blink.
Press “+/CH”, “–/CF” to set year data. Press “M/S” will have number “00” blink. press “+/CH”,
“–/CF” to set correct time zone. Press M/S to set month. When month blink Press “+/CH”,
“–/CF” to set data. Press “M/S” to set day. When day blink Press “+/CH”, “–/CF” to set data.
ALARM AND SNOOZE SETTING
● In normal display, press button “M/S” twice, display “AL”. Press button “+ / CH” will show “ ”.
Long press “M/S”, Hour number blink. Press up/down button “+/CH” “–/CF” to set hour.