EN - 5
Press “M/S”, turn to set minutes. Minutes digital blink.
Press up/down button “+/CH” “–/CF” to set minutes.
● After setting alarm time, press “M/S”, display “ “.
Setting snooze time (default: 5 minutes), Press up/down button “+/CH” “–/CF” to set
snooze time.
After setting snooze time, press “M/S” back to normal time display. (It will back
automatically under no operating within 30 seconds).
● Cancel alarm setting: On normal time display, press “M/S” Twice, display “AL”. Press “+/
CH”, cancel alarm. “
” will disappear.
BUZZER Alarm time is 2 minutes, Alarm way as follows:
● a.0–10 seconds, BI/second
● b.10–20 seconds, BI BI/second
● c.20–30 seconds, BI BI BI BI/second
● d.After 30 seconds, BI continuously
HUMIDITY AND TEMPERATURE
● “IN” is indoor data. When main unit work, it will sensor and display humidity and
tempeature automatically.
● “OUT” is outdoor data. When connect with remote sensor successfully, it will will sensor
and display data.
REMOTE SENSOR OPERATING INSTRUCTIONS
● Use screwdriver (included) to open remote. And Install battery AAAX2PCS (not
included).
● After install battery, remote will fl ash red light. And start transmit data.
● There have 3 channels for selecting. Please make sure remote sensor in same channel
with main unit channel.
● After setting well, can cover battery door and screw it well.
● Waterproof standard: IPX4
● Main unit “OUT” part will default channel 1.
● Short pressing “+/CH” to select channel 1, 2, 3. (have to as same channel as remote).
● Long pressing “+/CH”, “OUT” will appear red fl ashing light. Means search signal.
● When searching signal, please wait for 3~5 minutes for linking.
● When linked successfully, “OUT” part will display outside humidity and temperature data.
The unit will go into search mode automatically or you can press and hold the “+/CH” button
the unit will go into search mode (signal fl ashes on the outdoor display). When an outdoor
sensor is removed from a channel, the last readings remains on the display for one hour.
After one hour, it display blank “--°C--% (centigrade) “--°F--% (Fahrenheit).
When the sensor is move to another position the unit takes 1 minute to relink.
To Next Page
Loading...
