EN – 7
– Indoor &Outdoor temperature HI & LO alert (independent setting).
– 150countries Sunrise/sunset time
– Barometer pressure bar and value display
– Moon Phase & Tide Indicator
– 3-mode brightness: Bright/Dim/Off
– C/F(Celsius/Fahrenheit) switchable
– Max/ Min memory records
– Low battery indicator
– Tone on/off function
– Transmission range: up to 80 meters in open area
– Table standing or wall hanging
– Sensor Transmission Frequency:433.92MHZ
– Main Unit Power: 3*1,5V type AA (Batteries Not Included) & 5V 1.2A DC Adaptor(Included)
– Sensor Power:2*1,5V type AA(Batteries Not Included)
BUTTONS FUNCTION
– In standard mode, press the MODE button once to cycle through: time→AL1(M-F)→AL1(S-
S)→AL2(M-F)→AL2(S-S)
– In standard mode, press and hold the MODE button for 3 seconds to enter the time setting
– In alarm checking mode, press and hold the MODE button for 3 seconds to enter the alarm setting
– In standard mode, press and hold the ▲/CH button to clear all channel and re-register for reception
– In standard mode,press and hold the ▼/RCC button to manually enter RCC reception, and press
again during reception to exit RCC reception.
– In standard mode or RF reception mode, press the ▲/CH button to switch to check different channels
– In time and alarm clock setting mode, single press the ▲/CH button to increase by 1, press and hold
to increase by 8 steps per second.
– In time and alarm clock setting mode, single press the ▼/RCC button to decrease by 1, press and
hold to decrease by 8 steps per second.
– In standard mode, press the MEM button to view the maximum/minimum temperature and humidity
values within 24 hours
– When the maximum and minimum values are displayed, press and hold the MEM button for 3
seconds to clear the maximum and minimum temperature and humidity memory values at the same
time.
– In standard mode, press and hold the MEM button for 3 seconds to switch the temperature unit ºC/ºF
– In standard mode, press the ALERT button to switch among indoor and high and low alarm
temperature values for 3 outdoor sensor.
– In standard mode, press and hold the ALERT button to enter the alarm temperature value setting
– In standard mode, press and hold the CITY button for 2 seconds to enter city settings.
– In city setting mode, single press the CITY button to confirm and go to the next letter item
– When the alarm sounds, press the SNOOZE/LIGHT button to enter snooze, and any other button will
stop the alarm.
– In DC mode, when the backlight is on, press the SNOOZE/LIGHT button to switch the brightness
level.
– In DC mode, when the backlight is on, press and hold the SNOOZE/LIGHT button for 3 seconds to
enter the automatic Dim backlight time setting for night.
– In the setting state, press the SNOOZE/LIGHT button to save and exit the setting.
– In battery-powered mode, press any button to highlight the backlight for one minute.
To Next Page
