EN – 9
ALARM SETTING MODE
– In standard mode, single press MODE button to switch to alarm clock display mode
– Single press each time to switch AL1(M-F)’AL1(S-S)’AL2(M-F)’AL2(S-S). then it will return to time
display mode after 5 seconds of no operation; snooze time: 5~60 Minutes
– When checking the current alarm, press and hold the MODE button for 3 seconds to enter the current
alarm clock settings. Press the MODE button to go to the next setting item. The setting sequence is:
ON/OFF→Hour. →Minutes→Snooze time→Exit, when OFF is selected, display turn back to standard
time mode.
– When the setting item flashes at 1HZ frequency, short press the ▲/CH button to add 1, and long
press the ▲/CH button to quickly add up at 8 steps/second.
– When the setting item flashes at 1HZ frequency, short press the ▼/RCC button to decrease by 1, and
long press the ▼/RCC button to quickly decrease at 8 steps/second.
– If there is no operation for 1minute during the setting process, press the MODE button or the
SNOOZE button to save the current setting value and exit the alarm clock setting.
ALARM MODE
Alarm time: 2 minutes
Alarm Period: 0-10 seconds: BI once every second
11–20 seconds: BI BI twice per second
21-30 seconds: BI BI BI three times per second
31 seconds-11 minutes: continuous BI BI BI BI beep
– When the alarm sounds, press the SNOOZE/LIGHT button to enter snooze (5~60 minutes). There is
no limit to the number of snooze times. Press any other button to stop the alarm.
– In battery-powered mode, the backlight is off by default when the alarm sounds. After pressing the
button to stop the alarm, the backlight turns off automatically after one minute.
BACK LIGHT
– When DC powered, backlight brightness is 100%, 60%, 5%, OFF,
– When batteries powered, backlight brightness is 100%
– When DC power supply, after power-on ,the default backlight is 100% bright and always
on. press the SNOOZE/LIGHTbutton and the backlight will cycle between high brightness
100%→60%→5%→OFF.
– When Battery-powered, after power-on , the default backlight is 100% on for 1minute. When it is off,
press any button to highlight the backlight for 1minute. If there is button operation, the backlight will
be on. After the operation is completed, it will delay for 1minute and turn off.
AUTO-DIM BACKLIGHT FOR NIGHT
– The default night auto dim is OFF, backlight period is 22:00~8:00, high brightness is 100%, and low
brightness is 5%
– In normal display mode, press and hold the SNOOZE/LIGHT button for 3 seconds to enter the Auto-
Dim period setting. Press the SNOOZE/LIGHT button to enter the next setting item.
– The setting sequence is: Auto dim function ON/OFF→Start hour→Start minute→End hour→End
minute→Exit
To Next Page
Loading...
