To Next PageTo Next Page
Need help?Do you have a question about the Sennheiser ew 300 G4 and is the answer not in the manual?
General| RF power | 50 mW |
|---|---|
| Modulation | FM |
| Sensitivity | 2.5 μV |
| Certification | CE |
| HDX compander | Yes |
| Peak deviation | ±48 kHz |
| Antennas quantity | 2 |
| Channels quantity | 32 channels |
| Switching bandwidth | 88 MHz |
| Operating frequency type | Ultra High Frequency (UHF) |
| Radio Frequency (RF) range | 470 - 558 MHz |
| 6.35 mm (1⁄4-inch) output | 1 |
| Operating temperature (T-T) | -10 - 55 °C |
| Signal-to-Noise Ratio (SNR) | 115 dB |
| Number of receiving frequencies | 3520 |
| Total Harmonic Distortion (THD) | 0.9 % |
| Microphone type | - |
| Operating time | 8 h |
| Antenna type | Removable |
| Receiver type | Rack mount receiver |
| Antenna connector type | BNC |
| Receiver housing material | Metal |
| Transmitter type | Handheld transmitter |
| Operating voltage (receiver) | 12 V |
| Power consumption (receiver) (max) | 350 mA |
| Number of microphones included | 0 |
| Country of origin | Germany |
| Harmonized System (HS) code | 85181000 |
Weight and Dimensions| Receiver weight | 980 g |
|---|---|
| Transmitter weight | 450 g |
| Receiver dimensions (WxDxH) | 202 x 212 x 43 mm |
| Transmitter dimensions (WxDxH) | 50 x 50 x 265 mm |
Illustrates connecting XLR-3 and 6.3 mm audio cables to the receiver unit.
Shows how to insert batteries and indicates low battery status and charge levels.
Illustrates the on and off states for the receiver and transmitter units.
Explains how to navigate through device menus using UP, DOWN, ESC, and SET buttons.
Details core menu options like Easy Setup, Frequency Preset, Name, and Auto Lock.
Covers advanced settings such as Tune, Sync Settings, Pilot Tone, and Software Revision.
Instructions on how to change frequencies on SKM/SK transmitters and receiver units.
Demonstrates the process of synchronizing transmitters with the receiver using IR sync.
Guides through the Easy Setup for receivers, including frequency preset and scanning.
Explains how to adjust the squelch level to minimize unwanted noise.
Details how to set audio sensitivity and AF output levels for optimal signal.
Covers different muting options like AF Mute, Mute On/Off, and RF Mute.
Information on connecting to networks and using control software like WSM.
Shows compatibility with accessories like ME 2, MKE 2, and SL Headmic 1.
