4.9 Local Voice Mute
When the Model 1104 dials out to report an alarm, it also audibly
recites the alarm message at its installation site. The Local Voice
Mute command allows you to turn off the voice at the Model
1104’s site during alarm dialouts and status call-ins. This feature
is used to prevent intruders or unauthorized persons from hearing
the alarm dial-out message or from hearing the Status Report
during an off-site call.
4.9.1 Enable/Disable Local Voice Mute
To enable/disable Local Voice Mute:
1. Press SENSOR ON/OFF.
2. Press MUTE.
The Model 1104 will say “On” to indicate that Local Voice Mute
is enabled, or “Off” to indicate that it is disabled.
3. Repeat key sequence to switch between enabled or disabled
Local Voice Mute.
To Next Page