5.11 High Sound Alarm Enable/Disable
The Model 1104 monitors sound through the built-in microphone.
When the sound level suddenly exceeds the programmed high
sound limit, the Model 1104 will respond to an alert condition.
The increased sound level must continue throughout the
programmed recognition time. The default for high sound alarm is
enabled (on).
NOTE
The microphone is also used for listening to on-site
sounds. Refer to Chapter 4, Section 4.7. Disabling
the sound alarm does not affect listen-in capability.
5.11.1 Changing Enabled/Disabled High Sound Alarm
1. Press SENSOR ON/OFF.
2. Press SOUND. The Model 1104 will say “Off” to indicate
disabled or “On” to indicate enabled.
3. Repeat key sequence to change settings.
To Next Page
Loading...