appropriate input (thereby disabling any alarm dial-out response).
The input remains disabled until you issue the same command,
which effectively returns it to its former, enabled state.
Press the following push-buttons on the Touch-Tone
™ telephone
to execute the desired command:
* (asterisk), 1
...equal to Sensor On/Off, for input 1. To re-enable the input,
repeat the same Touch-Tone
™ button sequence used for
disabling.
* (asterisk), 2
...equal to Sensor On/Off for input 2, and so on, for inputs up
to 4. To re-enable the input, repeat the same Touch-Tone
™
button sequence used for disabling.
Disabling/enabling High Sound Monitoring –
* (asterisk), 9
...equal to SENSOR ON/OFF for High Sound Alarm
monitoring. To re-enable High Sound Alarm, repeat the
command.
Disabling/enabling AC Power –
* (asterisk), 0
...equal to Sensor On/Off for AC Power monitoring. To re-
enable AC Power monitoring , repeat the command.
Activating Listen-In Time –
# (pound), 1
...initiates Listen-In Time for listening to on-site sounds for the
programmed time available.
Activating Status Report –
# (pound), 2
...initiates a full recitation of the Status Report.
Exiting –
# (pound), # (pound)
...forces exit. The 1104 says, “Have a good day,” and hangs
up.
Chapter 6: Acknowledgment, Status Report & Remote Access
87
To Next Page
Loading...