18
STARTUP and PROGRAMMING
Apply Power
Caution: Before applying power,
double-check all wiring.
Once the installation has been completed,
and wiring has been checked, close the
door to the monitor and apply power. The
unit will go through its normal startup
checks and warm-up procedure. It is
important that the door remain closed to
ensure a proper operation.
Initial Screens
If the IR-SNIF-MCD has never been
programmed, it will access default memory
settings and display the following screen:
Once the defaults have been stored, or if
the monitor has been previously
programmed, the following screen will be
displayed. Since the monitor is factory
calibrated, and factory programmed during
quality control, it should display this screen
on initial application of power.
Following memory initialization, the monitor
will display the copyright screen.
The monitor will next display two Contact
and Model Information screens. (Note:
these screens can be accessed anytime
during normal operation by pressing the “*”
key.)
Following display of the contact and model
information screens, the IR-SNIF-MCD will
restore any alarms that have been saved
into memory. The corresponding lights and
relays will be energized. Any external
alarms, exhaust fans or building
management system connections will be
activated. The monitor will then display the
following optics warm-up screen.
restore from memory
Optics Warm up
Timer 540 12:00
RESETTING DEFAULTS
SenTech
Corporation
Phone 1-888-248-1988
Model IR-SNIF-MCD
Version 4261
Option Code 0
SenTech Corporation
IR-SNIF-MCD16
Gas Monitor
To Next Page
Loading...
Need help?
General
