STC – TC83USB-ASH
STC – TB83USB-ASH
II. Cautions
A. Trigger Input Signal Cycle Time
Set the trigger signal input cycle time to be more than the sum of the exposure time and the video
output, otherwise the following phenomenon may occur:
- Double images
- Excess or abnormal noise
- No video image.
B. Status of the Input Signal Pins at Power-up
All input pins must be set at “low” status when the power is turned on. Otherwise the camera may not
operate properly.
Product Specifications 10 of 11 Rev 1.1
To Next Page
Loading...
