Need help?Do you have a question about the SenTech STC-CL500E and is the answer not in the manual?
Details the pin assignments for Camera Link and Power/IO connectors.
Describes the input and output signals for the power/IO connector.
Illustrates the equivalent circuit for the power/IO connector input pin.
Details horizontal and vertical timing charts for Normal mode operation.
Details horizontal and vertical timing charts for Binning mode operation.
Explains the data order for different bit depths in CameraLink output.
Illustrates image data transfer for monochrome and color types using two taps.
Describes Normal mode operation with Frame exposure and Electronic shutter.
Explains Pulse width trigger mode, including V-Reset and Non-Reset.
Details Edge preset trigger mode, covering V-Reset, Non-Reset, and exposure timing.
Describes H reset mode for exposure without horizontal noises and SUB pulse generation.
Specifies the communication method as UART (RS232C) with binary communication.
Lists communication settings: Baud rate, Data bit, Parity, Stop bit, Flow control.
Details the data format for sending commands to and receiving data from the camera.
Provides a list and descriptions of camera control commands for operation.
General| Frame Rate | 30 fps |
|---|---|
| Weather Resistance | IP66 |
| Weight | 300g |
| Lens | 3.6mm |
| Night Vision | Yes |
| Power Supply | 12V DC |
| Operating Temperature | -10°C to 50°C |
| Storage Temperature | -20°C to 60°C |
To Next Page
