Sentex SPECTRUM Series - Verifying the Relay Activation Time (STEP 07); Setting Directory Code Length (STEP 08); Verifying Directory Code Length (STEP 08)

Page 8 of 15 Doc 6001573 Rev A
VERIFYING THE RELAY ACTIVATION TIME (STEP 07)
Purpose To verify the amount of time the door or gate will remain open.
Format 07 + #
Note Once you have pressed the “#” key, the display will show four digits. The
first two digits are the amount of time the door or gate attached to relay 1
will remain open and the remaining two digits are the amount of time
relay 2 will remain open.
SETTING DIRECTORY CODE LENGTH (STEP 08)
Purpose To tell the system how many digits will be in the code that a visitor uses
to dial a resident. Factory setting = 2 digits.
Format 08 + code length (may be 1, 2, 3, or 4) + #.
Example 08 + 3 (sets code length to 3 digits) + #.
Notes WARNING: Be sure the directory code length is set properly before you
begin entering telephone numbers. You may change this length later
BUT you will have to change all directory codes in the system to the new
length or the system will not function properly and you may run out of
capacity.
A 1-digit code length will handle up to 10 codes, 2-digit codes will handle
up to 100 codes, and 3- or 4-digit codes will handle up to 1000 codes.
VERIFYING DIRECTORY CODE LENGTH (STEP 08)
Purpose To verify that the code length in the system is what you think it is/want it
to be.
Format 08 + #.
Note Once you press the "#" key, the display will show the number of digits in
the directory code. For example, if you have 3 digits in the directory
code, a “3” will be shown on the display when you press the “#” key.