Symbol for “ENVIRONMENT PROTECTION
electrical products should not be disposed of with
household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling
, Against dripping(15° tilted)
Follow operating instructions
Caution or warning that requires special attention.
7
3. Getting Started
3.1 Unpacking
Before unpacking, examine the packing case carefully for signs of
damage. If any damage is detected, contact your distributor or
Sentier. If the packing case is intact, open the package and remove
the equipment and accessories carefully. Verify all materials are
present and check for any mechanical damage. Contact Sentier in
case of any problem at 844-VETCORDER.
Warnings and Cautionary Advice
Save the packing case and packaging material as they can be
used if the device must be reshipped.
Register your warranty at www.sentierconnect.com. You will
then be notified via email of any software updates etc.
When disposing of the packaging material, be sure to
observe waste control regulations and keep it out of the
reach of children and animals.
The equipment might be contaminated during storage and
transport. Before use, please verify whether the packages are
intact, especially the packages of single use accessories. In
case of any damage, do not use. Contact Sentier at 844-
VETCORDER for assistance.
3.2 Power On/Off
Press the Power On/Off button to power on the device. Press and
hold Power On/Off button for 2 seconds from the main menu to
power off the device.
3.3 Initial Settings
The first time when the Vetcorder is powered on, you can set up
your Vetcorder monitor step by step. You can also change the
settings in the <Settings> menu.
8
3.4 Turning On/Off Bluetooth
The Vetcorder Pro has built-in Bluetooth wireless connectivity,
which enables exporting measured records from the device to
mobile devices using Bluetooth protocol.
To turn on the Bluetooth: press the Home button to enter
Main Screen.
Swipe your finger from right to left to switch to the second
page and go to SETTINGS.
On that menu you will swipe your finger up to scroll down or
use the arrow on the lower right of the screen.
Find the Bluetooth line item and toggle the switch to the right
by tapping it – when the circle in that is on the right side the
Bluetooth is on and when that circle is on the left the
Bluetooth is off.
You can exit this menu by using the X in the upper right corner or
by using the home button to return to the starting screen.
4. Using Vetcorder
4.1 Prior to Use
Warnings and Cautionary Advice
Use only cables, electrodes, sensors, and other accessories
specified in this manual.
The device has no alarms and will not sound if the
measurement reading is too low or too high.
Before using ECG
Proper electrode placement is required to get accurate ECG
readings. Places where leads attach to the body must be prepared
correctly to ensure the best possible contact. Dogs and cats
usually have enough electrolyte material on their skin and hair so
that merely moistening lead sites with 70% isopropyl alcohol is
To Next Page
Loading...