Why is the motor temperature raised while the output speed is reduced in my Sentinel SHLM-10A?
Several factors can cause the motor temperature to rise while the output speed decreases. It could be due to voltage being too low, overloading the mixer, or using a mixing speed that's too high (or the wrong attachment). Check the power supply, reduce the load, and select a more suitable speed and attachment to resolve the issue.
What to do if my Sentinel SHLM-10A Mixer has oil leakage?
If your mixer is leaking oil, the seal rings are likely worn out. You should replace them.
What to do if attachments hit the bowl of my Sentinel SHLM-10A?
If the attachments are hitting the bowl, either the attachment or the bowl itself may be damaged. Repair or replace the affected component.
Why is there noise or high temperature coming from the gearbox of my Sentinel Mixer?
Noise or high temperature from the gearbox usually indicates insufficient lubrication. Try adding or replacing the grease.
How to fix a Sentinel SHLM-10A when the tool shaft does not rotate after starting the machine?
If the tool shaft isn't rotating after starting the mixer, the electric wiring may be loose. Check the electric wiring, plug, and cord.
Ensures correct voltage and grounding for safe operation.
Properly insert and secure the stirring shaft into the mixer.
Sequence for engaging the gear lever, power switch, and bowl lift.
Safe method for changing mixer speeds during operation.
Procedure for safely turning off the mixer and disconnecting power.
Used for stirring liquids like cream and egg at mid or high speed.
Ideal for batters like stuffing and cake dough, starting low, ending mid.
Designed for making dough, recommended at low speed.
The vessel for holding ingredients during mixing operations.
Safely disconnect the mixer and clean grinder components before assembly.
Securely fit the meat grinder to the mixer's attachment hub.
Remove bones and cut food into small pieces for the feeding inlet.
Use the provided feeding rod to push food into the grinding cavity.
Detach and clean the grinder after use to prevent bacteria growth.
Check nut tightness, plate blockage, or blade sharpness for poor results.
Wipe the machine body and clean attachments with warm, soapy water.
Oil the gear cavity and lubricate gear/shaft bearings every six months.
Ensure the grinding blade is sharp and free from damage.
To Next Page
General