2
SAFETY RULES
GENERAL SAFETY RULES (continued)
2
• Use only correct wheels. Do not use wheels with
incorrect size holes. Never use washers or arbor nuts
that are defective or incorrect. The maximum wheel
capacity of this saw is 7" (178 mm).
• Always use the splash hood.
• Never touch wheel or other moving parts during use.
• Never start tool with wheel in contact with
the workpiece.
• Use only recommended accessories.
• Make sure wheel is tight and not making contact with
saw or workpiece before connecting to power supply.
• Always hold workpiece firmly against the rip guide, miter
guide or bevel table.
• Never attempt to free a stalled wheel without first turning
the saw OFF and disconnecting the saw from the
power source.
• Avoid awkward operations and hand positions where
a sudden slip could cause your hand to move into the
cutting wheel.
CAUTION
Think safety! Safety is a combination of operator common
sense and alertness at all times when tool is being used.
WARNING
Do not attempt to operate tool until it is completely
assembled according to the instructions.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
To Next Page
Loading...
General