2. Connect Ethernet Cable
Please follow the instructions below to connect the FS-IP3000-M Ethernet cable.
The FS-IP3000-M supports an RJ-45 Dongle Cable.
RJ-45 Dongle
RJ-45 Dongle Cable Connection
Run the Ethernet cable through the Waterproof RJ-45 Screw-On Plug. Then connect one end of
the Ethernet cable to the RJ-45 dongle, tightening the sealing nut of the Waterproof RJ-45
Screw-On Plug completely. Next, connect the other end of the Ethernet cable to Power
Sourcing Equipment (PSE) like hubs or routers.
NOTE: Please use a PoE waterproof switch/hub so that the camera can work.
To Next Page
Loading...
