SEP LEM012SD User Manual

2 SEP LEMO12SD / LEM012SS 2015
1.1 Safety instructions
Information for Your Own Safety
This manual does not contain all of the safety measures for operation of the
LEM012SD/LEM012SS, because special operating conditions, local code requirements
or local, national or international regulations may necessary to take further measures.
It does contain information which must be adhered to in the interests of your own
personal safety and to avoid material damages.
Warning
Means that failure to observe the instruction can result in death, serious injury or
considerable material damage.
Caution
Means hazard of electric shock and failure to take the necessary safety precautions will
result in death, serious injury or considerable material damage.
Qualified personnel
Commissioning and operation of the equipment (module, device) described in this
manual may only be performed by qualified personnel. Qualified personnel in the
sense of the safety information contained in this manual are persons who are
authorized to commission, start up, ground and label devices, systems and circuits
according to safety and regulatory standards.
Use for the intended purpose
The single phase energy meter may only be used for the application cases specified in
the catalog and the user manual and only in connection with devices and components
recommended and approved by SEP Europe.
Proper handling
The prerequisites for reliable operation of the product are proper transport, proper
storage, installation and assembly, as well as proper operation and maintenance.
When operating electrical equipment, certain parts of this equipment automatically
carry dangerous voltages. Improper handling can therefore result in serious injury or
material damage.
 Use only isolated tools.
 Do not connect while circuit is live (hot).
 Do not connect the meter to a 3 phase - 400VAC – network.
 Place the meter only in dry surroundings.
 Do not mount the meter in an explosive area or exposed to dust, mildew and
insects.
 Make sure the used wires are suitable for the maximum current of this meter.
 Make sure the AC wires are connected correctly before activating the
current/voltage to the meter.
 Do not touch the meter connecting clamps directly with your bare hands, with
metal, blank wire or other material as you will have the chance of an electric shock
and a possible chance for health damage.
 Make sure the protection cover is placed after installation.
 Installation, maintenance and repair should only be done by qualified personnel.
 Never break the seals and open the front cover as this might influence the

SEP LEM012SD Specifications

General

Brand	SEP
Model	LEM012SD
Category	Measuring Instruments
Language	English