1
2
3
4
5
6
7
8
Remove all packaging from your dehydrator and its acces-
sories. Make sure all package list is included (see page 2).
Wipe and clean all parts of the equipment.
Place the dehydrator base on a solid and level surface.
Keep at least 6 inches from the wall. Plug in. Stack the
drying trays to the dehydrators.
Run the dehydrator for 30 minutes at any temperature
without adding any food. Make sure that the room has
sufficient ventilation, in case the dehydrator produces any
smoke or smells. This is normal.
Note: You only need to do this the first time you use the
dehydrator.
Rinse the trays in water. Dry all parts.
1
2
3
4
5
Note:
The temperature of the food dehydrator can reach up
to 190°F, please take care to avoid burns when open-
ing the unit.
Unplug the dehydrator and clean it after it cools.
If you used a recipe that left traces of liquid or other residue,
wipe the tray with a paper towel before cleaning.
Soak trays in hot water for easy removal of food residue.
Clean the trays with a soft brush.
Note:
Don't put the main engine into water or other liquids!
Dry all parts before storing or using the dehydrator.
Note:
Use the dehydrator in a warm, dry room. The dehydra-
tion time may vary due to the humidity in the air and the
moisture in the food.
1
2
GUIDANCE
HOW TO USE
Cut the food into slices, place food on trays and put the trays
to the dehydrator. The thinner slices, the shorter drying timer. If
less food, put them on the middle of dehydrator is suggested.
Plug in. The dehydrator will beep, and the display will show the
temperature and timer. Press , Set temperature and timer
by control panel.
Press button to change temperature (70°F-190°F).
Note: Temperature changes in 5°F increments. Press and hold
or to change the temperature rapidly.
Press button to change timer (0:00–24:00).
Note: Timer changes in 30 minute increments. Press and hold
or to change the timer rapidly.
With the sound, the dehydrator will start heating. Temperature
and timer will display until finished.
Note: If you press again to stop dehydration, the timer
countdown will reset and the dehydrator will go into standby
mode.
Optionally, you can change the timer and temperature at any
time by pressing timer or temperature button.
When the timer finished and heat will turn off. The fan of dehy-
drator will continue running for 30-40 seconds before stopping.
Note: The dehydrator will always remember your previous
temperature and timer settings.
Use the heat-resistant glove, or oven mitt to handle the trays.
To Next Page
Loading...