Warning! Do not dry the radio using a microwave oven or with any other
heating device.
Salt water
This radio is designed for use in salt water and salt mist environments. When operating in these
environments the radio must be customised with the Connector Protector feature. This feature
protects the Digital Accessory Connector (sDAC) at the bottom of the radio from corrosive damage
and the feature must be enabled before entering salt water environments. Refer to the product user
guide for more information on this feature.
A cover or an approved accessory must be fitted to the Rugged Accessory Connector (sRAC)
located on the side of the radio, to protect the connector whilst operating in salt water environments.
Salt water is corrosive and may damage the radio. If your radio is exposed to a salt water
environment or you are working in an area with high salt laden humidity, for example when operating
aboard a boat or within the vicinity of the sea in a harbour, using a protective case may reduce the
risk of product damage.
Caution! Damage to product. Battery MUST BE FITTED when rinsing
the radio under running water. The battery contacts within the battery
compartment must be protected from running water.
To clean after exposure to salt water:
1. Rinse under gently running clean water.
2. Gently shake the radio to clear any water from behind the keypad.
3. Dry the radio with a clean lint free cloth.
Allow the radio to dry before operating.
Warning! Do not dry the radio using a microwave oven or with any other
heating device.
18 SC20 Series hand-portable radio
To Next Page
Loading...
Need help?
General
