Safety Guidelines
Caution Do not operate the SET-2090 in a manner not specified in this document.
Product misuse can result in a hazard. You can compromise the safety protection built
into the product if the product is damaged in any way. If the product is damaged, return
it for repair.
Electromagnetic Compatibility Guidelines
This product was tested and complies with the regulatory requirements and limits for
electromagnetic compatibility (EMC). These requirements and limits provide reasonable
protection against harmful interference when the product is operated in the intended
operational electromagnetic environment.
This product is intended for use in industrial locations. However, harmful interference may
occur in some installations, when the product is connected to a peripheral device or test
object, or if the product is used in residential or commercial areas. To minimize interference
with radio and television reception and prevent unacceptable performance degradation,
install and use this product in strict accordance with the instructions in the product
documentation.
Furthermore, any changes or modifications to the product not expressly approved by SET
GmbH could void your authority to operate it under your local regulatory rules.
To ensure the specified EMC performance, operate this product only with
shielded cables and accessories.
To ensure the specified EMC performance, the length of any cable
attached to connectors J1 and J2 must be no longer than 3 m (10 ft).
ROHS Compatibility Guidelines
This product is fulfill the RoHS Directive 2011/65/EU on the restriction of the use of certain hazardous
substances in electrical and electronic equipment.
To Next Page
Loading...