When there is error for the fridge, there will be code on the display. The possible error for each code would
be as follows
ERROR
CODE
ERROR TYPE
E2
Fan error/Short circuit/ Frequently start and stop
E4
The motor speed of the compressor is too low (the refrigeration system is overloaded,
the motor cannot maintain the minimum speed of 1850r/min)
E6
NTC fault (NTC open circuit or short circuit)
E1
The low battery protection mode take effect (the input voltage is lower than set value)
E3
Compressor motor start error (Motor block or refrigeration system pressure difference is too large.)
E5
Temperature too high or too low to protect the compressor control module (when the environment
temperature is too high or too low, or system load is too large, causing module/ECU internal
temperature 100 °C > or < - 10 °C)
11.FAULTS
07
To Next Page
Loading...
