Failure to obey the following notices could result in property damage:
●
Keep sand or dirt away from the cooling system ventilation area.
●
Do not leave the cooler on the deck of a boat for an extended period. Salt water damage to the
cooling system, electronics, or metal hardware could occur.
●
Do not expose the cooler to extreme heat.
●
Only use mild soap and water to clean the cooler.
●
Do not use a DC extension cord.
●
Do not use a power strip or two-way splitter.
●
Do not use power cord adapters of any kind other than those provided by the manufacturer.
●
Do not use ice cubes or fill the cooler with water. If ice does accumulate at the bottom of the cooler,
defrost the unit and use the drain plug to drain the water.
●
Do not modify the unit in any way.
●
Do not place hot materials (75 °F or higher) in the cooler. Allow materials to cool (50 °F or less)
before placing them inside the cooler.
●
Do not tip or store the cooler at an angle greater than 30° for extended periods. Compressor oil
contamination of the cooling system could occur.
●
Allow 2–4 inches of space around the cooler at all times for proper ventilation of the cooling system.
●
The cooler must be secured at all times using straps or a mounting plate, especially in mobile
applications.
06
10.NOTICE
The power supply cable must be replaced only by qualified technical personnel and in any case
by an after sales service authorised by the Manufacturer.
in this manual.
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
SetPower is not liable in any way if you do not comply strictly with all the previsions
This appliance is not intended for use by persons (including children) with reduced physical, sensory
To Next Page
Loading...
