Need help?Do you have a question about the SEW-Eurodrive MOVIDRIVE MDA90A-0480-503-X-S00 and is the answer not in the manual?
General| Brand | SEW-Eurodrive |
|---|---|
| Model | MOVIDRIVE MDA90A-0480-503-X-S00 |
| Category | Control Unit |
| Language | English |
Ensures basic safety notes are observed and work is done by qualified specialists.
Intended for control cabinet installation; specifies applicable directives and motor types.
Product must not perform safety functions without a higher-level safety system.
Safety notes for startup and operation, including handling of dangerous voltages and hot surfaces.
Provides instructions and warnings for the mechanical installation of modules.
Steps for installing an axis system with power supply, axis modules, and controller in a control cabinet.
Safety notes and requirements for electrical installation, including dangerous voltages and leakage current.
Points to observe when installing braking resistors, including dangers from high DC voltage and heat.
Recommendations to optimize system EMC and eliminate interferences.
General safety warnings for startup, including uncovered power connections and unintentional motor startup.
Illustrates the startup procedure divided into segments using MOVISUITE® software.
Lists and explains faults related to the power supply module, including subfaults for unknown unit, EEPROM, voltage, etc.
Details faults related to axis modules, categorized by fault number like Output stage, Ground fault, Brake chopper, etc.
Defines default fault responses and parameterizable fault responses for various conditions.
Provides detailed performance data for MDP power supply modules, including electrical and mechanical specifications.
Provides technical data for MDA and MDD axis modules, including performance data and electronics data.
Provides technical data for braking resistors, filters, and chokes.
Information on underlying standards and safety classes for functional safety.
To Next Page