13
3 Operation
z Warning %LEL
Measuring range
Name of application with speci-
cation of measurement unit
Measurement data
Measurement data display
You cannot input any information until the device has stopped
cycling through the displays. The device is not in measuring mode
until the Measurement data screen is displayed.
Note:
When the device is switched on, the sensors must
warm up. The duration of the warm-up time depends
on the sensor type.
After switching on the device, changing the measur-
ing range or setting the zero point, you may notice
the reading ashing on the display. The device is
only ready for use when the displayed reading stops
ashing.
z Measuring VOL%
Measuring range
Name of application with speci-
cation of measurement unit
Measurement data
Measurement data display
To Next Page
