27
3 Operation
3.3 Advanced settings
Settings for the following areas of the device can be made in the
advanced settings:
z Adjustment
z System
z Hardware
z Memory
You cannot perform measurements in the advanced settings.
3.3.1 Access
There are two ways to access the Advanced settings area:
The device is switched off:
z Simultaneously press the , and keys for approximately
2 seconds.
The device is in measuring mode:
z Simultaneously press the and keys for approximately
2 seconds.
The following display appears:
Access is protected by a PIN code. The default setting is always
PIN code 0001.
The device can be set so that only authorised users have access
to the Info menu.
It is advisable to reset the PIN code after starting the device for
the rst time.
To Next Page
