PAGE 35
PAGE 34
8. MAINTENANCE - REFILLING TRIMMING LINE
1. For replacement line, use a line with diameter of 2.4mm
(.095in). The spool is capable of holding up to 2.5m.
Avoid using a larger line as it may reduce the trimming
performance.
2. Pinch the slotted area on the both sides of the spool hous-
ing to unhook the bottom cap.
3. Take out the spool and pull off the old line. Put one end of
new line through the spool holes and pull it until the length
is equal between each part of the line.
4. Wind up the line in the correct direction as indicated on the
spool.
5. Hook each end of the line in the slot on the edge of the
spool, and then put the ends through the eyelets on the
housing. Make sure that the spring and the washers are in
place.
6. While holding the spool against the housing, pull the line
ends to release them from the slot.
7. Line up the slot on the bottom cap with the hook on the
housing, press the cap against the housing until it clicks.
8. For safety reasons, do not use metal reinforced line.
9. TRANSPORTING THE STRIMMER
When you finish using the strimmer in one location
and wish to continue work in another spot, turn off
the engine, lift up the unit and carry it, paying at-
tention to the hot engine.
Be careful not to spill any fuels during
transportation to another spot.
When transporting the unit over long
distances, ensure the engine is cool to the touch,
and that any fluids cannot spill out.
To Next Page
Loading...
