It is very dangerous to run a chainsaw with broken or missing
parts. Before starting the engine, make sure that all the parts
including bar and chain are installed properly.
STARTING THE ENGINE
1. Fill fuel and chain oil tanks respectively, and tighten
the caps securely.
8. STARTING THE ENGINE
2) Fuel
1) Chain oil
2. Set the switch to “I” position.
Switch
Choke
3. Pull out the choke to the closed position.
WARNING
8. STARTING THE ENGINE
When restarting immediately after stopping
the engine, leave the choke knob at the open
position.
5. While holding the saw unit securely on the ground, pull the
starter rope vigorously.
4. Press the primer until fuel is visible.
6. When engine has startered, push in the choke to the
first-stage position.
7. Allow the engine to warm up with the throttle lever pulled
slightly.
ZZ
NOTE
To Next Page
Loading...
