SGS SC24H - User Manual

Questions and Answers

W
wadegregoryAug 9, 2025
What to do if the motor of my SGS SC24H is unable to run, is running slow, or is getting hot?
- D
  Derek WaltonAug 9, 2025
  If the motor of your SGS Air Compressor is not running, running slowly, or overheating, consider these potential causes and solutions: * Check the line for any faults or insufficient voltage. * The power wire might be too thin or long; replace it if necessary. * A fault in the pressure switch could be the issue, requiring repair or replacement. * There might be a fault in the motor itself, also needing repair or replacement. * The main compressor might be sticking; check and repair it.
S
Scott KerrAug 14, 2025
How to fix shaking or abnormal noise in my SGS SC24H Air Compressor?
- F
  Faith FreyAug 14, 2025
  Shaking or abnormal noise in your SGS Air Compressor can stem from several issues: * A connecting part might be loose; check and retighten it. * There could be a foreign body in the main compressor; check and remove it. * The piston might be knocking the valve seat; replace it with a thicker paper gasket. * Moving parts might be seriously worn, requiring repair or replacement.
E
edwardchangAug 20, 2025
Why is the pressure insufficient or discharge capacity decreased in my SGS SC24H Air Compressor?
- M
  martineznancyAug 20, 2025
  Insufficient pressure or decreased discharge capacity in your SGS Air Compressor can be caused by several factors: * The motor might be running too slow, so it should be checked and fixed. * The air filter could be clogged, requiring cleaning or replacement. * There might be leakage from the safety valve or discharge pipe, which need inspection and repair. * The sealing gasket could be damaged and in need of replacement. * The valve plate might be damaged, stuck, or have carbon buildup, necessitating replacement and cleaning. * The piston ring and cylinder may be worn or damaged, requiring repair or replacement.
D
derrickmillerAug 27, 2025
Why is my SGS Air Compressor showing excessive oil consumption?
- S
  Samuel MartinAug 27, 2025
  Excessive oil consumption in your SGS Air Compressor can occur due to: * The oil level being too high; keep it within the set range. * A choked breather pipe; check and clean it. * Worn or damaged piston rings and cylinders; repair or replace them.
D
duranbenjaminSep 1, 2025
What to do if the main compressor of my SGS Air Compressor is sticking?
- J
  Jeffrey GrantSep 2, 2025
  If the main compressor of your SGS Air Compressor is sticking, it might be due to: * Moving parts burnt because of insufficient oil. Check the crankshaft, bearing, connecting rod, piston, piston ring, etc., and replace if necessary. * Moving parts damaged or stuck by a foreign body. Check the crankshaft, bearing, connecting rod, piston, piston ring, etc., and replace if necessary.