CHAPTER V ENGINE TROUBLES AND REMEDY
A: ENGINE CAN NOT BE STARTED
tank or fuel cock not opens.
3) Fuel pipes or fuel filter blocked.
5) Lever not return to max.fuel supply position.
1) Fill in fuel or open fuel cock.
2) Discharge air by manual delivery pump.
3) Clean pipes and filter cartridge or replace cartridge.
4) Clean nozzle; Adjust injection pressure.
5) Pull the speed adjustor lever with force when starting
to force the lever to max. fuel supply position.
2) Lower voltage of accumulator
1) Tighten the circuit connecting screw.
2) Charge the accumulator.
3. High oil viscosity to lower the engine starting
speed.
3. Cranking the crankshaft for several turns with cranking
handle, or fill in preheated oil.
4. Ambient temperature too low.
4. Fill in hot water to pre- heat starting
5. Lower Compression Pressure in cylinder.
1) Cylinder liner, piston and piston rings worn out.
2) Valve and valve seat fitting not good.
4) Valve stem blocked in valve guide.
5) Air leakage from cylinder head gasket.
6) Air leakage from injector seat.
7) Valve timing incorrect.
3) Adjust clearance according to technical requirement.
4) Clean it in kero
5) Check cylinder head nuts torque. check whether the
gasket is broken .
6) Check nuts and packing for tightness and damage
6. Fuel supply advance angle not correct.
B: ENGINE POWER DECLINE
Trouble Cause,
1. Air filter or intake pipe blocked