sharkclean.com/AIRobotSEsharkclean.com/AIRobotSE
MAINTENANCE
EMPTYING THE BASE DUST BIN
The Base Dust Bin holds up to 60 days' worth of
dust and debris. Empty the base dust bin when the
debris level approaches the max fill line.
To detach the bin, press the Dust Bin Release
button on top right side of the base, then slide out
the bin.
To empty the bin, hold it over the trash, then press
the release button with the trash can icon on the
bottom of the bin. The bin lid will open, releasing
dust and debris. Lightly tap the dust bin against
the inside of the trash receptacle to knock o any
remaining debris. Reinstall the bin by sliding it into
the slot in the base until it clicks into place.
MAINTENANCE
EMPTYING THE ROBOT DUST BIN
Press the Dust Bin Release Button and slide out the
dust bin.
CAUTION: Turn o power before performing any maintenance.
To open the dust bin lid, press and hold the button
while lifting the lid, using the finger slots.
Empty debris and dust into trash. Remove filter and
wash dust bin if necessary.
NOTE: Make sure to insert the dust bin completely, until
it clicks into place.
Look between the filter and the plastic shield and
make sure there is no debris buildup.
Remove shield and clear any debris buildup with a
dry cloth or soft brush.
To Next Page
Loading...
Need help?
General
