sharkclean.eusharkclean.eu
USING THE SHARK® AI ROBOT VACMOP
WET MOPPING SETUP
When the reservoir has fluid and is properly installed,
with the mop pad attached, the robot is ready to
vacuum and mop simultaneously. Press the Clean
button on the robot or in the app to start a vacuuming
and mopping run. The robot will prime the mop pad
for 30 seconds before starting its run.
When mopping is complete, remove the reservoir by
pressing both buttons and sliding it out. Empty the
reservoir after each use.
CAUTION: Floors may be slippery after mopping.
NOTE: When mopping, your robot may travel over
floor mats or rugs. Before the next mopping run, move
rugs or mats out of the robot’s path, or use the app to
enable Carpet Detection or to set up no-go zones.
Before your robot’s first mopping run, set up Carpet
Detection in the app. This ensures your robot will
avoid carpets and rugs when mopping. Then follow
the instructions in the app to help the robot complete
its Explore Run, and then an initial vacuuming run.
Once the robot completes these runs, it will create
a map in the app, and you can select other areas for
the robot to avoid when mopping.
To remove the mop pad from the reservoir, detach
the pad from the back of the reservoir and slide the
pad out of the slot.
USING THE SHARK® AI ROBOT VACMOP
WI-FI TROUBLESHOOTING
• To use the app, your phone must be connected
to a 2.4GHz network. The app will only work on a
2.4GHz network.
• Typical home Wi-Fi networks support both 2.4GHz
and 5GHz.
• Do not use a VPN or a proxy server.
• Make sure Wi-Fi isolation is turned o on the
router.
•
DO NOT use Wi-Fi repeaters to connect your robot.
• If you cannot connect, visit sharkclean.eu.
ERROR CODE PROBLEM
! (RED) + Wi-Fi indicator (RED Flashing) Wrong password for Wi-Fi
! (Flashing red) + Wi-Fi (RED) SSID cannot be found, try connecting again
! + Wi-Fi (Flashing RED at the same time) Wrong user name or password for your SharkClean account
Wi-Fi (RED Flashing) Cannot connect to Wi-Fi
USING THE SHARKCLEAN APP
Please visit sharkclean.eu for answers to all your app questions.
Get the most out of your Shark AI Robot VACMOP with these app features:
• Recharge and Resume
Enable this feature to handle
multi-room cleaning in larger
homes. The robot will return
to the dock, recharge, and
can pick up where it left o.
• Carpet Detection
Once the robot has mapped
your home, activate Carpet
Detection in the app to
identify carpets and rugs for
the robot to avoid when it
mops.
• Scheduling
Set whole-home cleans for
any time, any day.
• Control From Anywhere
Wherever you are, you’re in
control of your robot.
• Cleaning Reports
Each time your robot cleans,
your app will generate a
cleaning report.
Search for SharkClean in the app store and download the app to your smartphone.
RUMPELSTILTSKIN
Schedule History
EDIT OPTIONS
MapsControl
Shark
Kitchen
Living Room
Dining Room
ENGLISH
To Next Page
Loading...
Need help?
General
