sharkclean.eusharkclean.eu
ANTI-HAIR WRAP TECHNOLOGY
®
MAINTAINING THE RESERVOIR AND MOPPING PAD
MAINTENANCE
The Anti-Hair wrap Technology
®
actively removes hair wrap while your robot
cleans. If some debris remains wrapped around the brush-roll, continue to run the
robot to give the brush-roll time to clean itself. If some hair wrap or debris remains
after continued cleaning, carefully remove it from the brush-roll.
To clean pads, machine wash warm with light
colors. Use mild detergents and do not use bleach
or fabric softeners. Air-dry, or tumble-dry on low
with no dryer sheets.
Empty the reservoir after each use. Rinse the
reservoir and let it air-dry. DO NOT put the reservoir
in the dishwasher.
To access the brush-roll, push up on the tabs on the
brush-roll door, then lift o the door.
Lift out the brush-roll and remove any debris.
Reinstall the brush-roll, inserting the flat end first.
Close the brush-roll door and press down until both
sides click into place.
NOTE: Replace brush-roll every 6 to 12 months, or when visibly worn. See sharkclean.eu for replacement parts.
NOTE: Before storing, make sure the reservoir and pad are completely dry. Store the reservoir and pad in a dry place to
prevent damage.
CLEANING SENSORS AND CHARGING CONTACTS
CLEANING SIDE BRUSHES
MAINTENANCE
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a dry cloth. To reinstall,
snap the brushes over the pegs. Spin the brushes
manually to make sure they are installed correctly.
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED. With a dry cloth, gently dust o the sensors
and contacts located on the bottom of the robot and on the dock.
NOTE: Remove and replace any side brushes that are bent or damaged. To remove a brush, lift it o its peg.
IMPORTANT: The robot uses cli sensors to avoid stairs and other steep drops. Sensors may work less eectively when
they are dirty. For best results, clean sensors regularly.
CLEAN SIDE BRUSHES AS NEEDED.
ENGLISH
To Next Page
Loading...
Need help?
General
