EasyManuals Logo

Shark AI Ultra RV2600WDEU User Manual

Shark AI Ultra RV2600WDEU
Go to English
123 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
sharkclean.eu sharkclean.eu
CHARGE INDICATOR LIGHTS
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your robot on a small
section of the floor to ensure there is no scratching.
NOTE: If the low charge light is blinking red, there is not enough battery power for the robot to return to the dock.
Manually place the robot on the dock.
The white charge indicator lights show how much
battery power is remaining.
While the robot is charging, both white LED lights
will flash. When charging is complete, both white
lights will illuminate steadily. It may take up to 6
hours to fully charge your robot.
If the robot is idle and away from the charging
dock for 10 minutes, it will enter Sleep Mode. The
indicator lights will turn o, but the battery and
Wi-Fi lights will remain on in sleep mode. Wake up
the robot by pressing any button.
In Use
Full
Charge
(White)
Partial
Charge
(White)
Low
Charge
(Red)
While
Charging
(White)
No Charge
or O
BUTTONS AND INDICATOR LIGHTS
DOCK BUTTON
Hold down for 5 to 7 seconds
to power on the robot. Press
to stop cleaning and send
robot back to the charging
dock.
CHARGE INDICATOR LIGHTS
Display the amount of charge
remaining in the battery.
WET MOPPING
INDICATOR LIGHT
The CLEAN button will
illuminate blue when the fluid
reservoir is properly installed.
The CLEAN button will
illuminate yellow if the tank is
empty and needs refilling.
!” ERROR INDICATOR
See Troubleshooting section
for full list of error codes.
WI-FI INDICATOR
White light: connected to
Wi-Fi.
Red light: not connected.
Flashing White: setup mode.
No light: not set up yet.
CLEAN BUTTON
Press to begin a cleaning
session and press again to
pause the cleaning session.
RECHARGE & RESUME
Press and hold the DOCK
button for 15 seconds to turn
Recharge & Resume ON or
OFF.
The Recharge & Resume function is turned OFF by
default. Turn ON Recharge & Resume for complete
coverage if your home's floor plan is bigger than
140m. Your robot will return to the dock, recharge,
and can pick up where it left o.
ENGLISH

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Shark AI Ultra RV2600WDEU and is the answer not in the manual?

Shark AI Ultra RV2600WDEU Specifications

General IconGeneral
BrandShark
ModelAI Ultra RV2600WDEU
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals