sharkclean.eu sharkclean.eu
CLEANING SENSORS AND CHARGING CONTACTS
CLEANING SIDE BRUSH
MAINTENANCE
Carefully unwind and remove any string or hair
wrapped around the brush.
Gently wipe the brush with a dry cloth. To reinstall,
snap the brush over the peg. Spin the brush
manually to make sure it is installed correctly.
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED. With a dry cloth, gently dust o the sensors
and contacts located on the bottom of the robot and on the dock.
NOTE: Remove and replace the side brush if it is bent or damaged. To remove the brush, lift it o its peg.
IMPORTANT: The robot uses cli sensors to avoid stairs and other steep drops. Sensors may work less eectively when
they are dirty. For best results, clean sensors regularly.
CLEAN SIDE BRUSH AS NEEDED.
CLEANING THE WHEELS
MAINTENANCE
CLEAN FRONT WHEEL PERIODICALLY.
See sharkclean.eu for replacement parts.
Clean the wheel housing.
Periodically clean the drive wheels and the housing
around them. To clean, rotate each drive wheel
while dusting.
NOTE: Brush not included.
NOTE: Side brush design may vary.
ENGLISH
To Next Page
Loading...
Need help?
General
