To keep your vacuum’s
suction power optimal, follow
these instructions. Make
sure unit is off and cord is
unplugged.
MAINTENANCE
RECOMMENDED
FILTER CLEANING
SCHEDULE:
Pre-Motor Filter Kit
(Foam & Felt)
XFF680
Clean every 3 months.
Post-Motor Filter
(HEPA)
XHF680
Clean once a year.
EMPTYING THE DUST CUP
1 Press down on Dust Cup
Release button and lift
dust cup off pod.
2 Hold dust cup over a trash
bin and press the latch
on the bottom of the dust
cup to empty it.
3 Press top Dust Cup Empty
latch to access dust
screen and remove built-
up debris asrequired.
CLEANING THE FILTERS
1 Pre-Motor
(foam and felt):
With the dust cup
removed, take out the
foam and felt filters, and
rinse with water. Tap loose
dirt off filters between
washes asneeded.
2 Post-Motor (HEPA):
To access the HEPA filter,
reach under the grill,
press the button, and pull
the grill away from the
vacuum. Remove and
rinse the HEPA filter.
STEP 1 STEP 2 STEP 3
WARNING: To reduce
the risk of shock and
unintended operation,
turn off power and
unplug unit before
servicing.
Hand wash only with
water to prevent
damage from cleaning
chemicals. Allow
ALL filters to air-dry
completely before
replacing them in the
vacuum to prevent
liquid from being drawn
into electricparts.
IMPORTANT: Do not use
soap when cleaning the
filters. Do not scrub HEPA
filter material.
HEPA
FELT FILTER
FOAM FILTER
FILTER FRAME
Filter Access
To Next Page
Loading...
Need help?
General
