EMPTYING THE DUST CUP
To remove Dust Cup, press button on top of
dust cup. Tilt dust cup forward, then lift to
remove.
To reinstall, place bottom of dust cup into
pod and then tilt back until it clicks into place.
To empty debris into trash, press lower release
button and bottom of dust cup will drop open.
To remove collected debris from Lint Screen,
press top release button and lift handle to
open. Gently brush lint screen to clean.
CLEAN HEPA FILTER
EVERY YEAR
Press button at bottom of Filter Door. Tilt
Filter Door and lift out. Remove HEPA Filter.
To reinstall, insert HEPA filter into unit and
replace the filter door.
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove Dust Cup, then lift out Filters.
Regularly clean and replace your filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water only to prevent damage from cleaning chemicals. Allow all
filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn
into electricparts.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
Filter
Door
Filter Access
To Next Page
Loading...
Need help?
General
