Why does my Shark Pressure Washer spray wand leak?
A leak in the spray wand of your Shark Pressure Washer can occur if the spray wand is not properly attached (slide the spray wand into the gun and turn the wand collar clockwise onto the spray gun threads until tight).
Why is there presence of water in the pump oil of my Shark BR-442537?
The presence of water in the pump oil of your Shark Pressure Washer can be due to water sprayed at the machine (change the oil and direct the spray away from the machine) or high humidity in the air (check and change the oil twice as often).
What to do if my Shark BR-442537 garden hose connection leaks?
If the garden hose connection on your Shark Pressure Washer leaks, it could be due to loose fittings (tighten the fittings) or a missing/worn rubber washer (insert a new washer).
What to do if my Shark BR-442537 engine lacks power?
If your Shark Pressure Washer engine lacks power, the air filter might be dirty (replace the air filter).
Why is water leaking from the pump protector of my Shark BR-442537 Pressure Washer?
Water may leak from the pump protector if the spray gun is closed with the machine running for 5 minutes or longer (open the spray gun or turn off the machine) or if there is excessive water supply pressure (place a pressure regulator at the end of the 50’ garden hose).
Why is my Shark BR-442537 Pressure Washer pump noisy?
If your Shark Pressure Washer pump is noisy, check that hoses and fittings are airtight, as the pump may be sucking in air. Turn off the machine and purge the pump by squeezing the trigger gun until a steady flow of water emerges through the nozzle.
What to do if my Shark Pressure Washer has pressure low after a period of normal use?
If your Shark Pressure Washer has low pressure after a period of normal use, it could be because the nozzle is worn (replace the nozzle) or the unloader valve is worn (replace the unloader valve).
Why is my Shark Pressure Washer engine overloaded?
Your Shark Pressure Washer engine might be overloaded because the nozzle is partially blocked (clean the nozzle) or due to excessive pressure from high engine RPM (adjust the engine throttle to lower RPM).
What to do if my Shark BR-442537 engine operates for 15 minutes then stops?
If your Shark Pressure Washer engine operates for 15 minutes and then stops, it could be due to insufficient gas or engine oil (fill the tank with gas and check the oil level), vapor lock developed by the heat of the day (keep the gas tank full to avoid vapor locking), or an obstruction in the fuel filter (clean or replace the fuel filter).
What causes fluctuating pressure in my Shark BR-442537?
Fluctuating pressure in your Shark Pressure Washer can be caused by an obstructed nozzle (use the nozzle wire in the accessory kit) or the pump sucking air due to a leaking inlet hose (check all pump lines and connections).
General| Brand | Shark |
|---|---|
| Model | BR-442537 |
| Category | Pressure Washer |
| Language | English |
To Next Page
